VOLKTEK NSH-9308P Uživatelský manuál stáhnout pdf (Strana 20)

You can modify the following parameters of RSTP function to accommodate your network.

System Configuration

z System Priority – A value to identify the root bridge. The bridge (switch) with lowest value has

the highest priority and will be selected as the root. 16 numbers are provided in this field from 0

to 61440 in increments of 4096, default value is 32768.

z Hello Time -- the time interval (seconds) between Spanning-Tree Protocol configuration

messages transmitting. Enter a value between 1 and 10, default value is 2.

z Max Age – the time interval (seconds) bridge (switch) will wait before attempting to reset STP

parameters when missing Spanning-Tree Protocol configuration messages. Enter a value

between 6 and 40, default value is 20.

z Forward Delay -- the time before bridge (switch) changes its ports from STP learning and

listening states to the forwarding state. Enter a value between 4 and 30, default value is 15.

z Force Version – normal: use RSTP; compatible: compatible with old STP protocol

Port Configuration

z Aggregations – Enable/disable the RSTP protocol on aggregation links.

z Protocol Enabled – Enable/disable the RSTP protocol per port basis.

z Edge – Enable/disable a port to be an edge port (connect to an end station).

z Path Cost – A value on a port that switch uses to determine which port will be the forwarding

port, if there are more than one path to the root bridge. The port with lowest path cost will be the

forwarding port. The value can be set from 1 to 200000000 or “auto” to be automatically

generated.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 30 31

Žádné komentáře

VOLKTEK NSH-9308P Uživatelský manuál Strana 20